A-282 Network Control Board

A-282 Network Control Board

Microair
SKU:
ASY-426-xxx
£491.53
(No reviews yet)
Current Stock:
Description

Replacement A-282 Network Control Board

A redesigned, newly manufactured replacement control board. Drop-in compatible with existing electrical boxes.

Guides & Information

Before You Buy

The A-282 Control Board is part of a legacy DX & TW cabin control system sold from the late 1990s to the present. Discontinued by the Original Equipment Manufacturer, it is now exclusively available from Micro-Air, which originally produced it for the Marine OEM and has since improved it for your replacement purchase today. It was also utilised in a specialty Class A Coach/RV application where the Cruisair-manufactured air conditioner was installed in the “basement” of large RVs.

The original board featured five 6-pin jacks and a plug-in DIP style ROM chip with markings that identified the application by the colour of the label on the board. The Cruisair boards had a number (42,600) printed on them. All connections from the board to components were made along one side using spade-style connections. The boards measured 7” x 6.4” [17.8cm x 16.3cm].

These boards come in three configurations:

  • Yellow-labeled boards directly drive a compressor in direct expansion marine applications.
  • Blue-labeled boards are used in an air handler for chilled water marine applications.
  • Red-labeled boards are used for Class A RV coach applications.

Select the correct application from the drop-down box before ordering.

This board replaces Cruisair part number 42600-07 and Dometic part number 701500101. These control boards were used on SMX-net systems and Cruisair RN, FN, SN, and SNR units.

Features

The A-282 preserves the following special legacy features unique to this particular control board:

  • Legacy OEM network capability
  • Auxiliary Heat in DX and Coach applications
  • Outside Air Temperature Sensor support
  • Virtual Pump Relay operation via networking
  • Two-speed fan output support
  • Compatibility with all original legacy control displays, including 6-pin RJ-12 display and network interfaces